3
SAFETY SUMMARY
GENERAL:
READ THE INSTRUCTION THOROUGHLY BEFORE ASSEMBLY. FOLLOW THE
SEQUENCES FOR PROPER. ASSEMBLY AND OPERATION.
NOTICE:
THE INSTALLATION, MAINTENANCE OR REMOVAL OF THE ANTENNA REQUIRES
QUALIFIED, EXPERIENCED PERSONNEL. ANDREW INSTALLATION INSTRUCTIONS HAVE
BEEN WRITTEN AND ILLUSTRATED FOR SUCH INSTALLATION PERSONNEL. THIS SYSTEM
SHOULD BE INSPECTED ONCE A YEAR BY QUALIFIED PERSONNEL TO VERIFY PROPER
INSTALLATION, MAINTENANCE AND CONDITION OF EQUIPMENT. ANDREW DISCLAIMS
ANY LIABILITY OR RESPONSIBILITY FOR THE RESULTS OF IMPROPER OR UNSAFE
INSTALLATION OR MAINTENANCE PRACTICES.
220 VAC, THREE PHASE POWER IS USED IN THE OPERATION OF THIS EQUIPMENT THAT IS
DANGEROUS AND MAY BE FATAL IF CONTACTED BY PERSONNEL. EXTREME CAUTION
SHOULD BE EXERCISED WHEN WORKING WITH THIS EQUIPMENT. WHILE EVERY
PRACTICABLE SAFETY PRECAUTION HAS BEEN INCORPORATED IN THIS EQUIPMENT, THE
FOLLOWING RULES MUST BE STRICTLY OBSERVED.
KEEP AWAY FROM LIVE CIRCUITS:
Operators and maintenance personnel must at all times observe safety regulations. Do not change plug-in
components or make adjustments inside the equipment with high voltage supply on. Under certain conditions
dangerous potentials may exist in circuits with the power control in the OFF position due to charges retained
by capacitors. To avoid casualties always remove power, then discharge and ground by use of a ground rod,
prior to touching any parts.
- Do not remove covers or access plates on the equipment unless you are authorized to do so.
- Do not work on electronic equipment unless there is another person nearby who is familiar with the
operation of the equipment and is trained in administering first aid.
- To prevent electrical shock or damage to the equipment, do not operate it until you thoroughly understand the
operation and function of all controls, indicators and connectors.
To Next Page
Loading...
Need help?
General
