44
3.3.4.1 Installing the SSR Tilt Scale Bracket - Refer to Figure 3-11 and Table 3-8.
A Tilt Scale Bracket and mounting hardware is included with Hardware Kit 174265 to interface
between the PSR antenna and the Tilt Scale and Pointer that are included with the Cossor SSR
antenna.
a) Attach Tilt Scale Bracket, 175157, to 3.5 inch long slot located on the front surface of the PSR/SSR
Interface Mount, 174050. Use qty.2 screws, lock washers and nuts, items 14, 16 and 17 and qty.4
flat washers item 15. Flat washers should be used under bolt heads and on opposite surface under the
lock washer and nut.
b) Attach the Tilt Scale (supplied with the Cossor SSR Antenna) to the top of the Tilt Scale Bracket
using qty.3 screws, flat washers, lock washers and nuts, items 10, 11, 12 and 13.
c) The Tilt Scale Bracket has slotted holes in both mounting surfaces to allow for adjustment of the Tilt
Scale. Refer to the SSR installation instructions supplied by Cossor for the Tilt Scale adjustment
procedure. When complete tighten all hardware fully.
To Next Page
Loading...
Need help?
General
