Anilam 6000M - Page 129

CNC Setup Utility Manual
P/N 70000490C - Index
All rights reserved. Subject to change without notice Index-1
10-December-04
3-D probe type (MC_1150), 2-10
3-D probe, description, 5-16
6000M CNC Programming and Operations
Manual, P/N 70000487, referenced, 2-57,
2-90
6000M Integral Programmable Intelligence
User’s Guide, P/N 70000488, referenced,
3-3
6300M, 1-1
6400M, 1-1
A
acceleration feedforward tune, manual test,
5-12
accessing, setup utility, 1-6
activate tool-length offset (MC_5000), 2-65,
2-87, 2-88
activation options, tool management, 2-86
analog spindle
maximum motor speed (rpm) (MC_2942),
2-42
motor phase (MC_2943), 2-43
pos. control integral gain (MC_2944),
2-43
pos. control integral limit (MC_2945), 2-43
arrow keys, illustration, 1-2
aspect ratio correction factor (MC_1109), 2-6
auto tab to previous line’s position
(MC_1203), 2-12
automatic feedrate override on arcs
(MC_4310), 2-62
automatic file loader
description, 2-78
laser file, to load, 2-78
automatic tool changer, settings, 2-88
automatic tuning
tuning mode, description, 5-1
tuning modes, listed, 5-1
automatically check disk at startup
(MC_1303), 2-13
auto-tune
axes motors, table, 5-3
current display, illustration, 5-3
spindle motors, table, 5-3
spindle motors, table, current auto-tune,
5-3
auto-tuning controller
current, procedure, 5-2
frequency, procedure, 5-4
position, procedure, 5-8
velocity, procedure, 5-5
auxiliary, axes, 1-6, 2-70
axes
auxiliary, 1-6, 2-70
motors, table, current auto-tune, 5-3
supported, listed, 1-1
axis keys, 1-3
axis selector switch, illustration, 1-3
B
backlash compensation (MC_3030), 2-49
backlash compensation, setup parameters,
table, 2-49
backup, restore from, 4-2
ballscrew compensation
(MC_3050), 2-49
setup parameters, description, 2-78
setup parameters, table, 2-49
values, generate from, laser files, 2-81
baud (MC_1351), 2-14
bipolar, spindle output, 2-76
Both, description, 2-87
buffer size, DNC, 2-84
buffered mode, 2-84
builder messages
description, 3-1
enabling, 3-2
error messages, editing, 3-2
warning messages, editing, 3-3
C
case sensitive find (MC_1208), 2-13
check RPM to be within gear change
(MC_2976), 2-44
check spindle during gear change
(MC_2974), 2-44
circle adjustments (MC_1004), 2-3
circle centers (MC_1005), 2-3
clear key, illustration, 1-2
CNC startup mode (MC_4316), 2-62
CNC, defined, computer numerical control,
1-1
compare, configuration, 4-2
compensation cutoff angle (MC_1009), 2-3,
2-71
compensation cutoff angle, illustration, 2-72
computer numerical control. See CNC
configuration
compare, 4-2
copy, 4-1