Anilam 6000M - Page 17

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
All rights reserved. Subject to change without notice.
10-December-04
2-7
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter
Function Settings
User Definable Variables Setup Parameters
MC_1120:
User definable
variable #1120
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1121:
User definable
variable #1121
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1122:
User definable
variable #1122
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1123:
User definable
variable #1123
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1124:
User definable
variable #1124
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1125:
User definable
variable #1125
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1126:
User definable
variable #1126
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1127:
User definable
variable #1127
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1128:
User definable
variable #1128
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1129:
User definable
variable #1129
Variable defined by user to be used in
general CNC programming.
Integer value: 0 to 99999
Range (-99999–99999)
0 [Default]
MC_1130:
User definable
variable #1130
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1131:
User definable
variable #1131
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
(Continued…)