Anilam 6000M - Page 18

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
2-8 All rights reserved. Subject to change without notice.
10-December-04
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter
Function Settings
MC_1132:
User definable
variable #1132
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1133:
User definable
variable #1133
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1134:
User definable
variable #1134
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1135:
User definable
variable #1135
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1136:
User definable
variable #1136
Variable defined by user to be used in
general CNC programming.
No units assigned.
Range (-99999.0000–99999.0000)
0.0000 [Default]
MC_1137:
User definable
variable #1137
Variable defined by user to be used in
general CNC programming.
No units assigned.
Range (-99999.0000–99999.0000)
0.0000 [Default]
MC_1138:
User definable
variable #1138
Variable defined by user to be used in
general CNC programming.
No units assigned.
Range (-99999.0000–99999.0000)
0.0000 [Default]
MC_1139:
User definable
variable #1139
Variable defined by user to be used in
general CNC programming.
No units assigned.
Range (-99999.0000–99999.0000)
0.0000 [Default]
MC_1140:
User definable
variable #1140
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1141:
User definable
variable #1141
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1142:
User definable
variable #1142
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1143:
User definable
variable #1143
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1144:
User definable
variable #1144
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]