Anilam 6000M - Page 19

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
All rights reserved. Subject to change without notice.
10-December-04
2-9
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter
Function Settings
MC_1145:
User definable
variable #1145
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1146:
User definable
variable #1146
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1147:
User definable
variable #1147
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1148:
User definable
variable #1148
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
MC_1149:
User definable
variable #1149
Variable defined by user to be used in
general CNC programming.
Unit based (Inch or MM).
Range (-25000.0000–25000.0000)
0.0000 [Default]
(Continued…)