Anritsu MS2722C - Measurement Setup; Connect the Input Source; Editing and Entering Values; Selecting the Analyzer Mode

Measurement Setup
3-2 PN: 10580-00277 Rev. E Spectrum Master UG
3-2 Measurement Setup
Connect the Input Source
Connect the input signal or antenna to the appropriate test connector on the top of the
instrument. For connector descriptions, refer to Figure 2-10 on page 2-13.
Editing and Entering Values
• Parameter values that are ready for editing are displayed in red on the submenu key.
After changing the value, press Enter to set the new value.
• Some submenu keys have toggled parameter values (On / Off, Low / High). On these
submenu keys, the current value is underlined. Press the submenu key to toggle the
value.
• Use the arrow keys, numeric keypad, or rotary knob to change submenu key values,
to select list box options, or to enter filenames.
Selecting the Analyzer Mode
1. Press the Shift key followed by pressing the Mode (9) key on the numeric keypad to open
the Mode Selector list box (refer to section “Mode Selector Menu” on page 2-6).
2. Use the directional arrow keys or the rotary knob to highlight the desired mode, and
press the Enter key or the rotary knob to select.