Anritsu MS2722C - Page 96

Operation Error Messages
B-6 PN: 10580-00277 Rev. E Spectrum Master UG
Lock failed during initialization
One or more of the Phase Lock Loops failed to achieve lock status during startup. Insure that
the battery level is adequate for operation or that temperature is within acceptable limits.
Reset to factory defaults with either Factory Defaults, ESC+ON, or MASTER RESET,
System+ON. Caution: Use of MASTER RESET, System+ON, will erase all user saved
setups and measurement traces and return the unit to a fully Factory Default condition. If
the error persists, then contact your Anritsu Service Center.
Reference LVL Cal is OFF
Factory Calibration is OFF. Insure that the battery level is adequate for operation or that the
temperature is within acceptable limits. Reset to factory defaults with either Factory
Defaults, ESC+ON, or MASTER RESET, System+ON. Caution: Use of MASTER RESET,
System+ON, will erase all user saved setups and measurement traces and return the unit to
a fully Factory Default condition. If the error persists, then contact your Anritsu Service
Center.
IF Cal is OFF
Factory Calibration is OFF. Insure that the battery level is adequate for operation or that the
temperature is within acceptable limits. Reset to factory defaults with either Factory
Defaults, ESC+ON, or MASTER RESET, System+ON. Caution: Use of MASTER RESET,
System+ON, will erase all user saved setups and measurement traces and return the unit to
a fully Factory Default condition. If the error persists, then contact your Anritsu Service
Center.
Cannot set Delta Mkr Freq to Demod Freq
Marker to Demod frequency is only available with a primary marker as the selected marker.
Fan Failure
The system has determined that the fan should be running due to the internal temperature of
the unit, but cannot detect that the fan is actually running.