NOTE: One animated symbol will be shown on the console display
to conrm that the instrument has been activated.
NOTE: the curing light has a permanent memory therefore the last
cycle used will always be present the next time it is used.
NOTE: the bre optic should be placed as close to the material to
be cured as possible without touching it.
WARNING!
Operation: runs 2 consecutive cycles, rests 60 seconds.
NOTE: when a programmed cycle is activated, the LEDs (1, 2, 3,
B, R, L) indicate the time that elapses (in multiples of 5 seconds) and
turn o every 5 seconds of operation.
WARNING!
• The curing light is equipped with a system that signals malfun-
paragraph).
• The curing light is equipped with a cut-out.
Indicators.
• LED 5 and LED 1, green, constantly on.
• LED 5 and LED 2, green, constantly on.
• LED 5 and LED 3, green, constantly on.
•
Maximum curable thickness.
WARNING!
This thickness must not be exceeded as the layer may not be completely cured.
Safety guidelines
WARNING!
•
The light emitted may cause eye damage in the event of direct radiation without eye protection.
The light emitted may damage soft tissues (oral cavity mucous, gums, skin).
• People with eye diseases, such as those who have had cataracts removed or retina diseases must be adequately protected when the
curing lamp is used, for example with s uitable protective eyewear.
A click is heard when the two positions are reached. Do not turn any more once the click is heard.
• Do not pull the power cord.
• Do not expose the handpiece to excessive vibrations.
If cracked, broken or if there are any other faults, do not use the curing light on the patient and contact the technical service department.
To Next Page
Loading...
