EasyManua.ls Logo

Anthos A3 Plus - Hydraulic Saliva Ejector; 7 Hydrogroup Operation; Fill Cup And Bowl

Anthos A3 Plus
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
L
34
I
34
EN
A3 PLUS
-
OPERATING INSTRUCTION
6.6. Hydraulic saliva ejector
ThehydraulicsalivaejectorstartsrunningWhenthetubeisremovedfrom
the support.
Cleaning after each use.
Aspirateabout½litreofSTER3PLUS(CEFLAs.c.)dilutedina6%solution
(equivalentto60mlofproductin1litreofwater).
Cleaning the saliva ejector lter.
Thisoperationmustbecarriedoutattheendofeachworkday.
WARNING!
Put on gloves before attempting to perform this operation!
• Aspirateabout½litreofSTER3PLUSdilutedina6%solution(equivalent
to60mlofproductin1litreofwater).
In order to prevent possible dripping of liquids and secretions from the
lter(b)tobeextracted,aspirateonlyairforabout5seconds.
•Takeo󰀨thecap(a ) by turning and twisting at the same time.
•Removethelter(b ).
•Clean/replacethelter(code97290060).
•Putthelterandcapbackinplace.
NOTE: to prevent liquids and matter from dripping from the lter
taken out, suck air only for approximately 5 seconds before performing
these operations.
Routine maintenance.
Lubricate the o-rings ( c ) with S1 – Protection for o-rings lubricant.
7. Hydrogroup operation
7.1. Fill cup and bowl
Thebowlcanbeturned160°onthehydrogroupbyhand.
Thewatertocupspoutcanberemovedtoeasecleaning.
Control buttons.
Water to bowl.
Water to cup.
Bowlushingautomaticallystopsafter30seconds.
Bowlushingautomaticallystartsinthefollowingcases:
• When the "rinse position” button is pressed;
• When the "water to cup” button is pressed.
Hot water to cup.
Whenthisfunctionisprovided,hotwaterisalwaysdeliveredtothecup.
Adjusting the amount of water used to ll the cup.
•TurnontheoperatingunitholdingdowntheCupWaterDeliverybutton
on the assistant’s board.
NOTE: 2 BEEPs signal saving is in progress.
•Pressthewatertocupkeyoncetostartllingthecup.
•Oncethedesiredwaterlevelhasbeenreached,pressthewatertocup
button again making sure the BEEP stops:
Atthispoint,thenewwaterlevelinthecuphasbeensaved.

Table of Contents

Other manuals for Anthos A3 Plus

Related product manuals