Anthos A6 PLUS Series - Water Delivery Control Modifications

A5 - A6 PLUS - L6
EN
63
Adjusting the amount of water used to fill the cup.
• Turn on the dental unit holding down the button (B1) on the assistant’s
board.
1 intermittent BEEP signals saving is in progress.
• Press the button (B1) once to start filling the cup.
• Once the desired water level has been reached, press the button (B1)
again making sure the BEEP stops.
At this point, the new water level in the cup has been saved.
Changing bowl operation.
Water delivery to the bowl can take place in an untimed manner (ON/OFF
operation of the relative control button).
This modification is made by turning on the dental unit holding down button
(B2) on the assistant’s board.
A beep sounds to signal the selected operating mode.
• 1 BEEP: timed operation.
• 3 BEEPS: ON/OFF operation.
Timed operation is factory set.
Changing the water-to-bowl controller with water delivered to the
cup.
The controller that delivers water to the bowl when the button (B1) is
pressed can be turned on/off.
This modification is made by turning on the dental unit holding down
buttons (B1) and (B2) simultaneously on the assistant’s board.
A beep sounds to signal the selected operating mode.
• 1 BEEP: controller enabled.
• 3 BEEPS: controller disabled.
The controller is enabled by default.
Water-to-bowl controller modification upon recall of dental chair
RINSE POSITION.
The controller that delivers water to the bowl when the button (P5) is
pressed can be turned on/off.
This modification is made by turning on the dental unit holding down
buttons (P5) and (B2) simultaneously on the assistant’s board.
A beep sounds to signal the selected operating mode.
• 1 BEEP: controller enabled.
• 3 BEEPS: controller disabled.
The controller is enabled by default.
Water-to-bowl controller modification upon recall of dental chair
AUTOMATIC RETURN.
The controller that delivers water to the bowl when the button (P6) is
pressed can be turned on/off.
This modification is made by turning on the dental unit holding down the
dental chair’s buttons (P6) and (B2) simultaneously on the assistant’s
board.
A beep sounds to signal the selected operating mode.
• 1 BEEP: controller enabled.
• 3 BEEPS: controller disabled.
The controller is enabled by default.