1 SAFETY CONSIDERATIONS
1.1 Connecting the power supply
This device must be connected to a 48V supply either from a Clear Flow power injector or a POE
Ethernet switch. Please check the voltage and current rating to ensure correct supply is
used as failure to do so may damage the product and will not be covered under warranty.
1.2 Liquids
DO NOT place liquids on or near the devices at any time as this may damage the product. Out-
door devices must be mounted in the correct orientation to prevent water ingress.
1.3 Cleaning
Only use a damp cloth for cleaning. We do not recommend using solvent based products as this
may damage the case.
1.4 Repairs
No attempt should be made to carry out repairs on these devices unless trained or qualied to do
so. Opening the device may invalidate the warranty.
To Next Page
Loading...