13
Numeric figure four during frequency input. Selection of memory/scan bank “D” or “d” and search bank
“D” or “d” or “N” or “n”.
toggles the priority facility on/off (assuming that one has already been
assigned using the priority menu). The LCD legend “PRI” confirms when priority has been selected.
to access the priority menu where the data from a memory channel may
be assigned for priority use. The interval sampling time may also be specified.
Numeric figure five during frequency input. Selection of memory/scan bank “E” or “e” and search bank
“E” or “e” or “O” or “o”.
to initiate select scan (assuming that more than one memory channel
has already been tagged for select scan). The LCD legend “SEL” indicates when select scan is active.
or or to exit select scan.
Numeric figure six during frequency input. Selection of memory/scan bank “F” or “f” and search bank “F”
or “f” or “P” or “p”.
to access the program search menu where upper / lower frequency
limits etc for search mode may be entered.
Numeric figure seven during frequency input. Selection of memory/scan bank “G” or “g” and search bank
“G” or “g” or “Q” or “q”.
to access the configuration menu where the beep, lamp, LCD contrast,
RS232 etc. may be configured.
Numeric figure eight during frequency input. Selection of memory/scan bank “H” or “h” and search bank
“H” or “h” or “R” or “r”.
to access the edit menu when memory channels and search banks may
be amended and copy protection configured.
Section 1-5-2
To Next Page
Loading...
