AOR AR8200 - DELETE Memory Channel Protect; DELETE Select Scan Channels

96
If no memory data exists in the selected memory bank, the legend “MEM-BANK X--” will be displayed.
If memory data does exist, the legend “MEM-BANK Xxx” will be displayed with the “xx” number
(00 to 89) indicating that data is present. To delete MEM-BANK data , the legend
“MEM-BANK Xxx“ confirms deletion.
to exit the menu returning to the standard display, alternatively the ò key
to move to the next item in the menu “DELETE SEL-CH”.
10-4 DELETE select scan channels
It is possible to delete all SELECT SCAN channel ‘tags’ using the DELETE menu.
While in search mode, the DELETE menu is accessed using the key sequence
, (while in scan or VFO mode use the key sequence ).
the ò key four times to move the cursor to the “DELETE SEL-CH” selection point.
If SELECT SCAN channels exist, the legend “SEL-CH xx” will be displayed with the “xx” number
(00 to 99) indicating that data is present. If no select scan channels exist the legend “SEL-CH --” will be
displayed. To delete all select scan channels , the legend “SEL-CH --” confirms
deletion.
If even a single select scan channel is write protected, the select scan bank cannot be deleted, you must
remove the protection first. You may remove the write protection for all memory channels in one go,
refer to section 11 of this manual.
to exit the menu returning to the standard display, alternatively the ò key to
move to the next item in the menu “CH PROTECT”.
10-5 DELETE memory channel protect
It is possible to remove the write protection from all memory channels in one go using the DELETE
menu.
While in search mode, the DELETE menu is accessed using the key sequence
, (while in SCAN or VFO mode use the key sequence
). the ò key five times, the LCD will temporarily display
“MEM PROTECT CH SEARCH ! ! ” as the AR8200 checks to see which memory channels are write
protected (if any). The menu selection “CH PROTECT” will be displayed after a few seconds.
If any memory channels are write protected, the legend “PRO-CH xx” will be displayed with the “xx”
number (00 to 89) indicating that data is present. If no memory channels are write protected, the legend
“PRO-CH --” will be displayed. To remove all memory channel write protection , the
legend “PRO-CH --” confirms deletion. The memory channels are not affected other than the protect
status being switched off.
Section 10-3, 10-4, 10-5