Apache Labs ANDROMEDA ANAN-7000DLE MKII - 2.2 Rotary Encoders

ANDROMEDAManual Page11of56
d. TheconfigurablemultimeterdisplaycanshowseveralRXandTXindications;the
currentlyselectedRXandTXsettingsareshown.
e. Totherightofthemultimeter,theATUsettings areshown.Thereisasliderthat
popsupifarotarycontrolisturned,toshowitscurrentposition.

f. FinallytheVFOB/RX2displayisattherightofthebar.
Thetopbarindicationsareasfollows:

VFO
Display
box
Litblue ifCLICKTUNE
Currentmode VFOfreq uency
Currentbandsegment
IndicatesMUTE
To prow:nosereduction; noiseblanker;
spectralnoise blanker;ANF
Bottomrow:AGCspeed,attenuation
Centre
Section
RX1/VFOAselected
BlueifVFOA/BSYNC
RX2/VFOBselected
Rotarycontrolposition(auto‐hide s)
ATUindicator
RXandTXmetermodes
VFOStep
BlueifSplitRX/TX
Multimeter
2.2 RotaryEncoders
6dualencodersprovidearangeofRXandTXcontrols.
2.2.1 VFO
TheVFOencodercanbeselectedtocontrolVFOAorVFOB.InmostcasesVFOAwilloperateRX1
whileVFOBwilloperateRX2.TheVFOcontrolledbytheencoderisselectedusingtheA/B
pushbutton.TheindicatorbythebuttonislitifVFOAisselected.

Theencoderprovides480stepsperrev olution.With10HzstepsselectedforVFOtuning,that
correspondsto4.8KHzperrevolutionwhichisideal for SSBandCWoperation.