Apache Labs ANDROMEDA ANAN-7000DLE MKII - 6.1.5 More TX Settings; 6.2 CW Operation; 6.2.1 Connecting a Key; 6.2.2 Receiving CW

ANDROMEDAManual Page26of56
6.1.5 MoreTXSettings
ThereareseveralTXsettingsavailableonthe“modedependentsettings”form.Therearefour
differentversionofthatformforSSB/AMaudio,CW,FManddatamodes.

ForAM/SSBvoice:
MicgainandMicMute;
Voicecompressor;
VOX;downwardexpander;
TXprofileselection;
TXSSBfilterwidth;

RX,TXequaliseron/off;
ShowTXfilterwidthinPanadapterdisplay.

ForFM:
Micgain;
FMdeviation;
CTCSStones;
Memorychannelselect;
TXprofileselection;
Repeateroffset

ForDatamodes:
PCaudio(VAC )RX,TXgain;
TXprofileselection;
Audiosamplerate;
Mono/stereoselection
Formoredetails,pleaseseetheThetismanual.

6.2 CWoperation
CWoperationsisenabledbyselectingtheCWLorCWUoperatingmodes.Theydifferentonlyin
usingloweroruppersideband,whichmakesnodifferencetoyourCWsignalbutaffectsthe
panadapterdisplays.ItissuggestedtobeginwithCWU.
6.2.1 ConnectingaKey
Akeycanbeconnectedtotheradio.Itcanbea“straight”key,oraniambickeyerpaddle.
6.2.2 ReceivingCW
1. SelectCWUmode.
2. OpentheModeSettingsformfromtheTXMenu
3. SelecttheIambicboxifyouuseapaddle.
4. SelectPitchFreq(Hz):to600
5. SelectShowCWZeroline
6. TuneasignalusingtheVFOknob.
7. Ifthebandisverybusyandmanysignalsarepresent,selectRX1intheModeSettingsform
toenabletheAudioPeakingFilter(APF).SetitsTunesliderto0,Bandwidthsliderto200,
Gainsliderto10