23
© 2014 Dectro International. All rights reserved.
ADJUSTING THE SETTINGS
To modify your settings, you must first select the
desired mode you wish to use and press the
Treatment ( ) button (located at the top right
corner of the home page). The unit will display the
treatment screen as shown on the left page.
The mode name
To edit, return to the Home Page by pressing the
little house at the top right corner.
Delay between impulses
In thermolysis modes only, allows you to enter the
desired time between two or more rapid impulses.
Starting current
In Blend mode only, you can choose which current
you want to enable first, high-frequency or Galva-
nic. When working in Blend most prefer to start with
Galvanic current (default selection-represented by
a battery).
Thermolysis energy level
The energy deployed into the follicle according to
the settings used in thermolysis. See chart below.
ENERGY LEVEL (Ɛ.L.)
Hair Type
Ɛ.L. Isolated Ɛ.L.
Fine Hair 100 75
Medium Hair
250 150
Coarse Hair 400 300
Ɛ.L. = HF Time × Intensity
2
× Number of Impulse
Units of Lye in Blend/Galvanic
The energy deployed into the follicle according to
the settings used in Blend or Galvanic. See chart
below.
TABLE OF UNITS OF LYE
Hair Type Quantity
Fine Hair 20 U.L.
Medium Hair 40 U.L.
Coarse Hair 60 U.L.
Very Coarse Hair 80 U.L.
U.L. = Glv. Time × (intensity ×10)
Home Page
Takes you back to the main menu.
Current date and time
To change, go to the configuration menu.
Chronometer
Allows you to enter the desired duration of the
treatment and to activate the alarm.
Timer
Timer is activated when you press the pedal to start
the treatment or if you press the Treatment ( )
button. To stop treatment, press the button again
Programs by region
Allows you to select the region of the body or the
face to be treated (by pressing on the circle) and to
select the size of the hair from 0 (very fine hair) to
9 (very coarse hair). To switch the program over for
treating a man, press the Male button.
To Next Page
Loading...