How to fix 'Tm temperature out of range' error on Applied Biosystems GeneAmp PCR System 9700?
To fix the 'Tm temperature out of range' error on your Applied Biosystems Laboratory Equipment, check the input value and retry.
What to do if Applied Biosystems Laboratory Equipment has no beep?
For the Applied Biosystems Laboratory Equipment, check Run-Time Beep configuration.
Why Applied Biosystems GeneAmp PCR System 9700 cooling fan does not make whirring sound?
To fix the issue where the Applied Biosystems Laboratory Equipment instrument cooling fan does not make a whirring sound, verify that the power switch is on, the power cord is connected, and check the fuses.
What to do if Applied Biosystems Control Unit displays message 'Valid range is'?
To solve this problem with Applied Biosystems Control Unit, reenter a value within the parameters of the field.
What to do if Applied Biosystems GeneAmp PCR System 9700 cycling time is too long?
Run cycle test diagnostic for Applied Biosystems Laboratory Equipment.
What to do if Applied Biosystems Control Unit has no screen display and no response when turned on?
To resolve this issue with Applied Biosystems Control Unit, ensure the power switch is ON, the power cord is connected, and check the fuses.
What to do if Applied Biosystems Control Unit displays 'Remove infinity hold first'?
To resolve this issue on Applied Biosystems Control Unit, add segments prior to the post-PCR infinity hold.
How to fix 'User name already defined' on Applied Biosystems Laboratory Equipment?
To address a 'User name already defined' error on the Applied Biosystems Laboratory Equipment, ensure that you do not duplicate user names.
What to do if Applied Biosystems Laboratory Equipment says 'Not enough method memory left'?
To resolve the 'Not enough method memory left' error on your Applied Biosystems Laboratory Equipment: ? Determine the available storage memory on the instrument or PC card. ? Delete or store rarely used methods elsewhere.
Why is my Applied Biosystems GeneAmp PCR System 9700 making too much noise?
If the Applied Biosystems Laboratory Equipment is making too much noise, check for any obstructions in the side vents.
General| Temperature Range | 4°C to 99.9°C |
|---|---|
| Temperature Accuracy | ±0.25°C |
| Temperature Uniformity | ±0.5°C |
| Block Format | 96-well |
| Temperature Uniformity at 60°C | ±0.5°C |
| Display | LCD |
| Power Requirements | 100-240V, 50/60Hz |
| Sample Capacity | 96 samples |
| Sample Volume Range | 10-100 µL |
Procedures for powering on, configuring settings, and customizing instrument parameters.
Guide to choosing, viewing, searching, and sorting PCR methods.
Steps to start, monitor, and pause a PCR run using the instrument.
Procedures for stopping, aborting, reviewing history, and handling run completion.
Guide to creating new methods and modifying cycling parameters like holds, cycles, and pauses.
Steps for naming, storing, printing, editing, and deleting created methods.
Step-by-step instructions for safely replacing the instrument's external fuses.
A table of error messages, their causes, and recommended actions.
A table listing common problems, their causes, and suggested remedies.
To Next Page
