Applied Precision RS 2130 User Manual

Reference Standard RS 2x30, RS 1x30
User’s Guide
www.appliedp.com RS-UG91-EN
19
3.2.25 Quantities Menu
This menu contains list of quantities which device measures or calculates from the measured quantities.
Displaying of selected quantities may be switched-on (ON) or switched-off (OFF). Up to seven
quantities can be displayed simultaneously. In case that only one quantity is chosen, the Large font
parameter, which determines if measured quantities are displayed in capitals or small fonts, is applied.
3.2.26 Harmonic Graph Menu
Harm. graph - parameter enabling (ENABLED) or banning (DISABLED) harmonic items of
measured signals graph displaying, if the FFT module of signal analysis is
present,
Background - parameter switching-on (ON) or switching-off (OFF) displaying of the noise
background in the graph of harmonic items of measured signals,
Max. freq. - parameter setting the maximal frequency displayed in the graph of harmonic
items of measured signals
3.2.27 Contrast Menu
Increase (+) - display contrast increase
Decrease (-) - display contrast decrease
Store - display contrast value storage into the device memory
3.2.28 Control Port Initialization Menu
Signal OUTx - parameter setting the initialization value (set after the device switch on) on the
appropriate bite of the user control port (value LOW corresponds to the logical 0,
and value HIGH to logical 1, respectively)

Applied Precision RS 2130 Specifications

General

Brand	Applied Precision
Model	RS 2130
Category	Measuring Instruments
Language	English