5.17.3 Commands
SYSTem:TALKonly {0 | 1}
General disabling (0) or enabling (1) of ‘TALK ONLY’ mode.
SYSTem:TALKonly?
Request for state of ‘TALK ONLY’ mode. Reply is 0 if disabled or 1 if enabled.
SYSTem:TALKonly:COM1 {0 | 1}
Disabling (0) or enabling (1) of COM1 (RS-232) output in ‘TALK ONLY’ mode.
SYSTem:TALKonly:COM1?
Request for state of COM1 (RS-232) output in ‘TALK ONLY’ mode. Reply is 0 if disabled or 1 if enabled.
SYSTem:TALKonly:COM1:FORMat {0 | 1}
Setting LONG format (0) or SHORT format (1) of COM1 output in ‘TALK ONLY’ mode.
SYSTem:TALKonly:COM1:FORMat?
Request for format setting of COM1 output in ‘TALK ONLY’ mode. Reply is 0 for LONG format or 1 for
SHORT format.
SYSTem:TALKonly:COM1:QUANtities {<qParam>}
Setting of quantities sent on COM1 output in ‘TALK ONLY’ mode. Quantities parameter (qParam) is
decimal number containing binary information about enabled/disabled quantities. For format of
parameter see detailed description in Mode ‘TALK ONLY’ chapter.
SYSTem:TALKonly:COM1:QUANtities?
Request for setting of quantities sent on COM1 output in ‘TALK ONLY’ mode. Reply is decimal number
containing binary information about enabled/disabled quantities. For format of parameter see detailed
description in Mode ‘TALK ONLY’ chapter.
5.17.4 Quantities parameter
Quantities parameter is 32-bit decimal word, used in commands for enabling/disabling of quantities.
Every quantity Qx is represented by bit X. Value 0 of this bit X disables quantity Qx and value 1 of bit
X enables quantity Qx.
Format of quantities parameter:
To Next Page
Loading...
Need help?
General
