APsystems YC500-A - IMPORTANT SAFETY INSTRUCTIONS

APsystems YC500-A Installation/User Manual 1
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS! This manual contains important
instructions to follow during installation and maintenance of the
APsystems photovoltaic grid-connected inverter (microinverter). To
reduce the risk of electrical shock and ensure the safe installation
and operation of the APsystems microinverter, the following symbols
appear throughout this document to indicate dangerous conditions and
important safety instructions.
WARNING: This indicates a situation where failure to follow
instructions may cause a serious hardware failure or personnel danger
if not applied appropriately. Use extreme caution when performing
this task.
NOTE: This indicates information that is important for optimized
microinverter operation. Follow these instructions closely.
SAFETY INSTRUCTIONS
✔ Do NOT disconnect the PV module from the APsystems
microinverter without rst disconnecting the AC power.
✔ Only qualied professionals should install and/or replace
APsystems microinverters.
✔ Perform all electrical installations in accordance with local
electrical codes.
✔ Before installing or using the APsystems microinverter, please
read all instructions and cautionary markings in the technical
documents and on the APsystems microinverter system and the
PV – array.
✔ Be aware that the body of the APsystems microinverter is the heat
sink and can reach high temperatures. To reduce risk of burns, do
not touch the body of the microinverter.
✔ Do NOT attempt to repair the APsystems microinverter. If it fails,
contact APsystems Customer Support (844-666-7034) to obtain
an RMA number and start the replacement process. Damaging or
opening the APsystems microinverter will void the warranty.
1

WARNING
SYMBOL

NOTE
SYMBOL