APT VEYRON E 8KW - Page 22

20
09
Output frequency
50Hz (default)
60Hz
10
Output voltage
220V
230V (default)
240V
11
Maximum utility charging
current
Note: If setting value in
program 02 is smaller than
that in program in 11, the
inverter will apply charging
current from program 02 for
utility charger.
30A (default)
Setting range is from 2A, then
10A to 120A. Increment of
each click is 10A.
12
Setting voltage point back
to utility source when
selecting “SBU” (SBU
priority) in program 01.
46V (default)
Setting range is from 44V to
51V. Increment of each click is
1V.
13
Setting voltage point back
to battery mode when
selecting “SBU” (SBU
priority) in program 01.
Setting range is FUL, and from 48V to 62V. Increment of each
click is 1V.
Battery fully charged
54V (default)