APT VEYRON E 8KW - Error Message for USB On-The-Go Functions; Timer Setting for Output Source Priority

30
Step 4: Please select setting program by following the procedure.
Program#
Operation Procedure
LCD Screen
:
Upgrade
firmware
This function is to upgrade inverter firmware. If firmware upgrade is needed, please check with
your dealer or installer for detail instructions.
:
Re-write
internal
parameters
This function is to over-write all parameter settings (TEXT file) with settings in the On-The-Go
USB disk from a previous setup or to duplicate inverter settings. Please check with your
dealer or installer for detail instructions.
:
Export data
log
By pressing “ ” button to export data log from the inverter to
USB disk. If the selected function is ready, LCD will display
“ ”. Press “ ” button to confirm the selection again.
 Press “ ” button to select “Yes”, LED 1 will flash once every
second during the process. It will only display and all
LEDs will be on after this action is complete. Then, press
“ ” button to return to main screen.
 Or press “ ” button to select “No” to return to main
screen.
If no button is pressed for 1 minute, it will automatically return to main screen.
Error message for USB On-the-Go functions:
Error Code
Messages
No USB disk is detected.
USB disk is protected from copy.
Document inside the USB disk with wrong format.
If any error occurs, error code will only show 3 seconds. After 3 seconds, it will automatically return to
display screen.
2. Timer Setting for Output Source Priority
This timer setting is to set up the output source priority per day.
Procedure
LCD Screen
Step 3: Press “ ”, “ ” or “ ” button to enter the selectable programs (detail
descriptions in Step 3).