19
Maintenance and repairs
Danger Where and in which sit-
uations does the dan-
ger occur?
Countermeasure
Incorrectly or inade-
quately performed
maintenance work with
limited visibility
Under poor light condi-
tions
If necessary, maintenance must
be performed with additional
lighting.
In this section, you will learn which work steps must be performed for the installation
and commissioning of the seed drill, and what must be done and observed.
4.1 Attaching the seed drill to a soil tillage implement
Purpose
For operation on the field, the seed drill can be attached to a soil tillage implement,
such as a cultivator or a harrow. The attachment must be installed individually.
Requirements
The following requirement must be fulfilled for this work step:
• The implement is disconnected from the power source, see Disconnecting the
seed drill from the power source On page 40.
Required components, tools and materials
For this work step, the following components, tools and materials are required:
Counter plate
Bolts with Ø > 10 mm, strength class 8.8 or higher
Self-locking fastenings (nuts)
Lifting gear that is suitable for the respective implement version, see Technical
Data On page 10 for more information.
4 Transport, installation and commissioning
To Next Page
Loading...
Need help?
General
