39
Step Description Explanation
2 Release the drive belt (7) from the
seeding shaft driving wheel (8) and the
agitator driving wheel (6) and put it
aside.
3 Close the bearing cover (1).
In this section, you will find information for eliminating faults that may occur during op-
eration.
6.1 Fault overview
Problem Cause Remedy
The seeding shaft does not ro-
tate when the drive shaft of the
gearbox motor is rotating
•
The fitted key fell
out of the drive
shaft
Stick on a new fit-
ted key
The seed hoses get clogged
•
Fan speed is too
low
Check the fan
speed and increase
if necessary
You can find more information on other faults in the operating manuals for the respec-
tive control boxes.
If the problem could not be fixed, please contact the manufacturer. You can find infor-
mation for this under Contact Service On page 5.
6 Faults
To Next Page
Loading...
Need help?
General
