To Next Page

To Previous Page

5.3 Regulating the seed flow rate (calibration test)

Purpose

During the calibration test, the seed quantity for a specific area is defined.

Requirements

The following requirement must be fulfilled for this work step:

• The implement is disconnected from the power source, see Disconnecting the

seed drill from the power source On page 40.

Required components, tools and materials

For this work step, the following components, tools and materials are required:

 Calibration bag

 Hexagon key

Procedure

This is how to perform a calibration test:

Step Description Explanation

1 Loosen the hexagonal bolt (2) on the

calibration slide (1).

2 Take the calibration slide out of the an-

choring and turn it by 180°.

3 Attach the rotated calibration slide back

onto the seeder.

Result:

4 Hook the calibration bag onto the cali-

bration slide.

5 Select a suitable brush pressure, see

Setting the brush pressure On page

35.

Other manuals for APV PS 120 M1

Questions and Answers:

Need help?

Do you have a question about the APV PS 120 M1 and is the answer not in the manual?

General