To Next Page

To Previous Page

Required components, tools and materials

For this work step, you need the following components, tools and materials:

• None

Overview

No. Designation

1 Brush adjustment lever

2 Setting scale

Procedure

This is how to set the brush pressure:

Step Description

1 Pull the brush adjustment lever (1) out of the setting scale.

2 Move the brush lever to the desired position and engage it in the appropri-

ate notch of the setting scale.

The following orientation rules apply here:

•

For fine seed, increase the brush pressure up to -5.

•

For coarse seed, reduce the brush pressure up to +4.

5.8 Filling the seed tank

Purpose

The seed tank stores the seed to be spread.

Requirements

The following requirement must be fulfilled for this work step:

• The implement is disconnected from the power source, see Disconnecting the

seed drill from the power source On page 40.

Required components, tools and materials

For this work step, the following components, tools and materials are required:

 Seed

Other manuals for APV PS 120 M1

Questions and Answers:

Need help?

Do you have a question about the APV PS 120 M1 and is the answer not in the manual?

General