To Next Page
K
Kathy WrightJul 27, 2025
How to fix a slipping Aquatec orca bathlift?
- SStephanie SchroederJul 27, 2025
If the Aquatec Lifting Systems bathlift slips, it's likely that the suction cups are old or damaged. Replace the suction cups.
How to fix a slipping Aquatec orca bathlift?
If the Aquatec Lifting Systems bathlift slips, it's likely that the suction cups are old or damaged. Replace the suction cups.
What happens if I tumble-dry Aquatec orca Lifting Systems covers?
Tumble-drying the covers of Aquatec Lifting Systems may cause damage.
Why is there no motor noise and my Aquatec Lifting Systems lift won't move?
If your Aquatec Lifting System's motor is silent and the lift isn't moving, it could be due to several reasons. First, ensure the hand control's jack socket is correctly locked. If that's not the issue, the battery might be flat, requiring a recharge. Dirty contacts could also be the culprit, so try cleaning them. Lastly, a damaged cable in the hand control might be the cause, necessitating a replacement of the hand control.
What to do if the Aquatec orca Lifting Systems battery does not charge and the red LED flashes?
If the battery of your Aquatec Lifting System isn't charging and the red LED flashes during charging, the electronics might be faulty, and you should have your authorized dealer check the hand control. Alternatively, the battery itself could be faulty, requiring a replacement of the hand control. Finally, the charger might be defective, so have it checked.
Why can my Aquatec Lifting Systems lift be raised but not lowered?
If your Aquatec Lifting System can be raised but not lowered, it's possible that the low-voltage protection has been activated. Recharge the battery.
What to do if my Aquatec Lifting Systems lift stops while being raised?
If your Aquatec Lifting System stops while being raised, it may be due to excessive load. Make sure to observe the maximum load.
Critical safety warnings for product use, handling, and maintenance.
Important safety advice for unpacking and initial setup, including transport damage checks.
Safety warnings concerning overloading, pinching hazards, and hand control moisture.
Instructions on operating the bath lift via the hand control and its movement directions.
Step-by-step guide for safely disassembling and removing the bath lift from the bathtub.
Table of common malfunctions, their possible causes, and recommended remedies.
General| Brand | Aquatec |
|---|---|
| Model | orca |
| Category | Lifting Systems |
| Language | English |