1 Introduction
4
1.2 Tool-Kit Recommendations
Below is a list of tools and supplies you may need to complete this
installation. Requirements for your vehicle may vary. Please consult
your vehicle service manual for additional recommendations.
1.2.1 Tools
Standard automotive sizes (metric and/or imperial) of sockets,
wrenches, allen keys, and drills.
A dial indicator or other suitable measuring tool for checking ring &
pinion backlash.
NOTE : Split ‘clamshell’ type Toyota differential housings
require a long series dial indicator to check backlash.
A razor knife for nylon tubing.
A torque wrench (See vehicle service manual for required torque
range)
A lubricant drain reservoir.
A slide hammer for removing CV axles.
Suitable measuring tools to measure a differential for preload
shimming. (e.g., an automotive feeler gauge)
An 11.2mm [7/16”] drill and ¼”NPT tap for bulkhead fitting
installation.
An automotive bearing puller (e.g., ARB Bearing Puller #0770001).
A bearing press or arbor press.
1.2.2 Supplies
Thread lubricant/sealant compound (e.g., LOCTITE #567)
Thread locking compound (e.g., LOCTITE #272)
High strength retaining compound (e.g., LOCTITE #620)
A gasket sealant or replacement gasket for your differential.
A sufficient volume of differential oil to completely refill your
housing. (see the ARB Air Locker Operating and Service Manual
for recommended lubricants)
A soap and water mixture to test for air leaks.
A selection of differential bearing shims to set-up preload and
backlash.
To Next Page
Loading...
Need help?
General
