Arcam AVR400 - Specifications

E-54
Continuous power output (20Hz—20kHz at 0.1% THD), per channel
2 channels driven 130W
All channels driven 90W
THD at 3dB below maximum power <0.2%
Residual noise & hum <0.3mV
Inputs
Line inputs:
Nominal sensitivity 1V–4V (user adjustable)
Input impedance 47k
Ω
Signal/noise ratio (CCIR, 65W) 100dB
Preamplier outputs
Max output level 6V RMS
Output impedance <50
Ω
THD+N (20Hz—20kHz) -100dB
Video inputs
Component video signal/noise 85dB
Composite video signal/noise 70dB
Headphone output
Maximum output level into 600
Ω 4V p-p
Output impedance <5
Ω
General
Mains voltage 110–115V or 220–240V
Power consumption (maximum) 1.5kW (ermal dissipation approx. 2300 BTU/hour)
Power consumption (idle, typical) 100W (ermal dissipation approx. 340 BTU/hour)
Power consumption (standby) <0.5W
Dimensions
W x D (including speaker terminals) x H (including feet)
435 x 440 x 172mm
Weight (net) 15.5Kg
Weight (packed) 20Kg
Supplied accessories Mains lead
CR102 remote control
4 x AAA batteries
Manual
DAB aerial (if DAB module tted)
FM aerial
AM loop aerial
Calibration microphone
E&OE
NOTE: All specication values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its
products. is means that designs and specications
are subject to change without notice.
specications