Argon 18 E-119 TRI+ - 13.2 BRAKE LEVER ASSEMBLY - ADAPTER FOR DI2 ROUTING

41
13.2 Brake Lever Assembly - Adapter for di2 Routing
1. Choose the Di2 sprint shifter adapter (included in SKU: 81513).
2. Insert the cable tie into the upper hole on the inside of the Di2 sprint
shifter adapter.
3. Choose the right SW-R9150 sprint shifter for the adapter side
you are assembling.
4. Run the cable tie through the SW-R9150.
5. Run the cable tie through the lower hole of the Di2 sprint shifter adapter.
6. Tighten the cable tie. The head must lie flat on the inside of the Di2 sprint
shifter adapter.
7. Cut the excess of the cable tie flush with the head using a flush cut pliers.
8. Set the Di2 sprint shifter adapter assembly into the brake lever. The shifter
must be on the same side as the M3 x 12 mm wedge screw head.
9. Apply grease to the thread of the M3 x 12 mm adapter screw.
10. Hand-tighten the M3 x 12 mm screw in the shifter.
11. Run the shifter cable through the cable groove on the lever.
12. Repeat for the other side.
SW-R9150
4
6Nm
2.5
1Nm
4
5.5Nm
4
7Nm
2
HT-1/4
5
12Nm
2
2Nm
3
3Nm
4
3Nm
8
35Nm
2.5
HT
3
HT
40Nm
4Nm
T25
T25
4
3Nm
10
HT
2.5
5
9Nm
2.5
HT-2
2.5
HT-5
2.5
2Nm
3
2.5
HTHT
3
4Nm
3
2Nm
6
10Nm
2.5
HT
4Nm6Nm
8
M3 x 12mm
included with:
81513
Left Right
Cable Tie
M3 x 12mm