Argon 18 KRYPTON PRO 302A - 3 Troubleshooting; Tips; Specification

KRYPTON PRO 302A 3. Troubleshooting / Tips / Speci cation
Brakes
Useonlyatmounthydraulicdiscbrakes. The frame and fork are
compatible with either 140mm or 160mm disc rotors. Adapters might be
required, consult brake manufacturer.
• Rear mount thickness: 25mm
Tire Clearance
The biggest tires that can be installed must be no wider than 34mm
(32c) for the rear and front wheel. If fenders are installed, the tires must be
no wider than 30mm (28c).
Seat Post
27.2mm
Seat Post Collar
31.8mm
Bottom Bracket
BB86(Press-t)
Headset (Krypton Pro specifi c)
FSANo30/Kit2+3DPress-t(Bearing11/8”,36°x45°topand11/2”,
36°x45°bottom+CustomKryptonProSteererCompressorincluded)
Stem
Non-reversible,-6°
Handlebar clamp size: Ø31.8mm
No more than 30mm of spacer can be placed between the stem and
the top cap of the 3D system. The headset expander plug must be
placed directly at the same height at the stem steerer clamping, or
else it will void the effi ciency of the compressor. These practices will
automatically cancel any warranty claim against the manufacturer.
Headset cap:
When uninstalling the headset cap, you
needtorstloosentheheadsetcap,
remove the HS cap screw and remove
the fork from the frame. Then you need
to pinch the rear section the headset
cap and lift the rear section upward.
This will release the headset cap from
the frame.
4