Argon 18 KRYPTON PRO 302A - Stack Height Adjustment

8
KRYPTON PRO 302A 4.3. Stack Height Adjustment
Note: Validate the required Stack Height before
proceeding with the cable routing.
• A total of 60mm of stack adjustment is possible.
• Using the Sizing Chart’s Stack and Reach columns
(p.6), determine the required 3D system headset
size (0mm, 15mm or 30mm) based on your
recommended handlebar position.
•30mmofproledspacersareprovidedtone-
tune your position:
(2x) Spacer 5mm (7.7)
(2x) Spacer 10mm (7.8)
1. Spacers must be installed with the tabs facing
upward. This feature ensure proper alignement with
the stem and between each spacer.
2. Open and slide-on the required spacers over the
front side of the steerer. Integrated tabs also guide
the spacers on the steerer tube’s front rib.
3. Twist-lock each spacer over the steerer tube
and stack them up between the headset Stack
Compressor (a.) and the Stem’s 1st Spacer (7.3).
7.8
7.7
a.
7.3