Ariston NIMBUS M NET - Detailed User Menu Functions; Thermal Cleanse, Connectivity, and System Info

User menu
20 / EN
3.6.1 Thermal cleanse function
Thermal cleanse function
Thermal cleanse function
OFF
Thermal Cleanse Cycle frequency 30 days
Thermal Cleanse start time [hh:mm] 01:00
Fig. 47
– "Thermal cleanse function": enables/disables the
thermal sanitisation of the DHW cylinder.
– “Thermal Cleanse Cycle frequency” (where
available): sets the frequency of the sanitisation cycle
(24 hours - 30 days).
– “Thermal Cleanse start time [hh:mm]” (where
available): sets the start time for the thermal
sanitisation cycle.
a
If the thermal sanitisation cycle is not completed
within the scheduled time, it will be repeated on
the following day at the specified time.
3.7 Connectivity
Connectivity
ON/OFF Wi-Fi Network
ON
Network configuration >
Serial number >
Re-configuration >
Signal Level 0%
Internet Time
ON
Fig. 48
– "ON/OFF Wi-Fi Network": Enables/disables the Wi-Fi
module connected to the system
– "Network configuration": Enables the configuration
of the Wi-Fi module present in the system. Read the
product instructions for further information.
– "Serial number": Displays the serial number of the Wi-
Fi device installed.
– "Re-configuration": Restores the factory settings of
the Wi-Fi device.
– "Signal Level": Displays the Wi-Fi signal strength on a
scale from 0 to 100.
– "Internet Time": Enables the acquisition of the system’s
time from the Internet
– "Internet weather": Enables the acquisition of the
outdoor temperature and the weather conditions from
the Internet
3.8 System information
System info
SW Version Interface
00.03.02
Zone number 1
System Performance >
Diagnostics >
Fig. 49
3.8.1 SW Version Interface
Shows the device’s software version.
3.8.2 Zone number
Shows the zone associated with the device.