Ariston NIMBUS M NET User Manual

User menu
23 / EN
3.10.4 Screen brightness
From this menu you can change the brightness of the display.
– Press the selector
to enter the edit mode.
– Turn the selector
to adjust the brightness of the
display when it is in active mode (from 10% to 100%).
– Press the selector
to confirm.
3.10.5 Standby settings
Standby settings
Brightness in standby
70%
Standby timing 1 min
Screen saver selection Room T
Fig. 59
– "Brightness in standby": allows to set the brightness
of the display when the device is in stand-by mode
(from 10% to 30%).
– "Standby timing": allows to set the time interval (from
1 to 10 minutes) from the last operation made on the
device, after which the screen enters stand-by mode
and its brightness is reduced to the value set for the
stand-by mode.
– "Screen saver selection": allows to select the type of
screen to be displayed in stand-by mode.
Standby settings
Brightness in standby
70%
Standby timing 1 min
Screen saver selection Room T
Room T
OFF
Fig. 60
– "OFF": displays the selected home page.
– "Room T": displays the current room temperature.
3.11 Advanced settings
3.11.1 CH settings
Advanced settings
CH settings
>
Cooling settings >
AUTO function ON
Buffer >
Heat Pump >
System measurement unit
International
system
Fig. 61
– "CH setpoint temperature": in the menu you can set
the water temperature set-point in heating mode for
each hydraulic zone present in the system. The menu
can be used to:
– adjust the temperature set-point if the automatic
temperature control function (“AUTO function”) is
disabled.
– apply a correction to the temperature set-point
using a slider, if the automatic temperature control
function (“AUTO function”) is active and the
water temperature does not match the desired
temperature.
T set Z1
0°C +-
Push Ok to confirm
Fig. 62

Ariston NIMBUS M NET Specifications

General

Type	Air-to-Water Heat Pump
Refrigerant	R32
Power Supply	Electric
Power Supply Voltage	230 V
Connectivity	Wi-Fi
Heating Capacity	6 kW