User menu
28 / EN
3.11.10 Time Program service type set
Sets the time schedule mode used by the device for heating
and cooling.
– "Two levels setpoint": the daily 2-level time scheduling
allows for dividing the schedule into a maximum of 4
comfort slots and 4 reduced-temperature slots within
the 24 hours of each day. It is possible to define a
temperature set-point for the comfort slot and one for
the reduced-temperature slot.
– "Multilevel setpoint": in daily multi-level time
scheduling, available only on specially configured
products, it is possible to define up to 12 daily slots,
each of which can be associated with a specific set-
point temperature.
Advanced settings
Cooling settings
AUTO function
System measurement unit
Time Program mode
Room temperature correction
Zones selection
Two levels setpoint
Multilevel setpoint
Fig. 71
3.11.11 Room Temp Correction
This parameter allows for correcting the room temperature
measured by the device by ±5°C.
3.11.12 Select the zones to manage
In this page you can select the hydraulic zones to be displayed
in the “Zones management” menu.
Select the zones to manage
Zone 1 Zone 5
Zone 2 Zone 6
Zone 3 All zones
Zone 4 Save
Fig. 72
3.12 Errors and diagnostic messages
HP communication error
Heat Pump TDM
Call the technical service
Error 910
Error 910 - HP communication error
Fr 4-JUN 12:30
Fig. 73
Diagnostic events (errors, alert messages, etc.) are shown in a
pop-up window in the home page.
The pop-up window shows the following information:
– Error code
– Error description
– Device/product that generated the error
– Any actions to be implemented for solving the problem
The pop-up window can be closed by pressing the Back button
. The error notification will remain visible in the home page
where the error icon , the error code and description are
displayed.
The window with the detailed information will automatically
pop up again after one minute. It can also be opened manually
by pressing the Back button again.
To Next Page
Loading...
Need help?
General
