C
hapter
Ⅳ
P
rogramming on
FAB
panel
ChapterⅣ Programming on FAB panel
The programming of a FAB is available for two methods : one way is to do the
operation directly on a LCD panel, and the other one is to program by using
QUICK II, the programming software, on a PC. Both of them are able to do the
FAB programming work. In this chapter we will present a detailed introduction to
the rst method.
As Fig. 4.1 shows, the LCD panel is a simple man-machine interface. All the pro-
gramming work can be done through the 8 keys on the right:
、 、 、
、 、 、 、 .
The following rules shall be observed for the programming on the panel:
1. When the cursor appears as an under-line, it can be moved:
a. Move the cursor along the lines with
、 、 and keys.
b.
c. Press the ESC key to exit the programming input.
2. When the cursor appears as >, the input/output or function block may be se-
lected:
Fig.4.1
41
Press the OK key to conrm the selection of an input/output connection or a
function block.
To Next Page
Loading...
