General Warnings, Training and Safety Notices - Read This First
Synergy
RF™
System Service Guide
DFU-0276-4r0_fmt_en-US Page 3 of 50
1. DO NOT – under any condition or for any reason – open the console (AR-
9800) or any other accessory.
2. Only use replacement power cords that meet medical grade standards
according to IEC 60320-1 Subclause 3.21, Detachable Power Supply Cords or
electrical standards for the designated country where the AR-9800 is being
used. Contact your Arthrex representative for further information.
3. Avoid positioning the console so that it is difficult to disconnect coupler or
plug from supply main.
4. To prevent electrical shock, do not use extension cords or 2 to 3 pronged
adaptors.
5. Always use fuses with the correct values to avoid allowing overcurrent to
enter the system.
6. An incorrect fuse may increase the risk of electrical shock or fire hazard.
7. This device has passed testing for EMI / RFI radiation and susceptibility and
EMC compatibility. This device may cause interference to other devices in the
near vicinity if not set up and used as Arthrex instructs.
8. Do not attach compatible disposable devices or footswitches during Self Test
or the Programming Modes.
9. Do not detach a disposable device or footswitch from the console while the
disposable device or footswitch is activated. The disposable device will stop
functioning if this is attempted.
10. Only use footswitches developed by Arthrex specifically for the AR-9800
Synergy
RF
console.
11. Only use disposable devices developed by Arthrex specifically for the
Synergy
RF
console.
12. The footswitch cable connects and locks to the console to prevent accidental
separation during use. To avoid damage, always disconnect the footswitch
by pulling on the cable connector shell (plug) only.
13. The accessory device cable connects to the console. To avoid damage, always
disconnect the accessory device by pulling on the cable connector shell (plug)
only.
14. Always comply with the instructions issued by the manufacturer of the
disinfectant.
15. NEVER use liquid to clean the accessory device connector contacts. Remove
dust regularly with dry compressed air.
16. Do NOT clean the device with abrasive cleaning or disinfectant compounds,
solvents, or other materials that could scratch or damage the device
17. NEVER allow the console receptacles to have any contact with liquids. If
there is dust or moisture on the receptacles, remove with dry compressed air.
ONLY dry connectors should be plugged into the console.
18. Liquid on the cable connector of the accessory device can damage the device.
Before connecting the cable, ensure the receptacles are clean and dry.
To Next Page
Loading...
Need help?
General
