Selecting and Loading a Scene
To select a Scene, hold down the Scene button and press one of the 16 step buttons. Empty
Scenes will be unlit, and loading them has no effect. Scenes with previously-stored content
will light up in blue.
♪: The Wait to Load Pattern [p.44] setting also determines when the next Scene will load.
Erasing a Scene
To enter Scene Erase mode, hold down Erase and press the Scene button. The 16 step
buttons will blink, waiting for you to erase a Scene. Empty Scenes will only blink once;
scenes that have content will blink in blue.
Pressing a step button now will erase all the Patterns and/or Chains that were stored in that
Scene. If you want you to erase several Scenes, keep the Erase button held down and press
the appropriate step buttons. Once erased, the selected step(s) will blink once in blue then
turn off.
Press the Exit button to exit Erase mode.
Switching Scenes
You can set Scene Launch Quantize in the Utility menu (SHIFT + Project). The options are 1
beat, ½ bar, 1 bar, 2 bar, 4 bar. This setting determines the precise point in time at which a
Scene, once loaded, will start playing.
♪: Scenes are saved in the KeyStep Pro's internal memory, so if you power down the KeyStep Pro
OFF and then switch it back ON, your saved Scenes will still be there.
All Patterns of all sequencers – but not the arpeggios – will reset when a new Scene is
loaded.
Arturia - User Manual Keystep Pro - What is a Project? 101
To Next Page
Loading...
