4.2.12. The Looper
The horizontal Looper Touch Strip (under the Pitchbend and Mod vertical touch strips)
enables you to alter the playback of a Project in real-time. It will generate longer or shorter
loops depending on where you touch the Looper Touch Strip and when you do it.
The Looper loops all tracks simultaneously. This includes CC# values that you may have
stored in the Control track.
4.2.12.1. Loop Length
The length of the loop is determined by where you place your finger on the Looper Touch
Strip, 1/4 being the longest loop and 1/32 being the shortest. Changing the placement of your
finger changes the size of the loop.
4.2.12.2. Loop Start Point
The start point of the loop depends on when you touch the Looper strip during playback. You
can jump to a different loop position by holding your finger on the strip and then pressing
one of the Step buttons. With the Looper, you can loop a range of steps in a sequence. The
length of the loop is determined by the indentation you press: 1/4, 1/8, 1/16 or 1/32.
Arturia - User Manual Keystep Pro - KeyStep Pro Overview 37
To Next Page
Loading...
