9.5.8. Touch Strip
This menu itum enables you to set the values the Looper will transmit when touched
9.5.8.1. MIDI Send/Receive
Use this menu to specify whether the KeyStep Pro's Looper Touch Strip will send MIDI
and react to incoming MIDI messages. The range of transmitted and recognized values is
detailed below in Using the Looper Touch Strip with a DAW [p.136].
9.5.8.2. MIDI CC
Use the value field to select the MIDI CC number that the Touch Strip/Looper will use to
transmit and receive.
9.5.8.3. Using the Touch Strip with a DAW
When the MIDI Send/Receive parameter is enabled, the activity on the can be recorded into
a DAW. By default, MIDI CC 9 values will be sent, but you can select a different MIDI CC#
as described above.
The Looper Touch Strip will send only the following values:
Looper Touch Strip Region MIDI CC value
1/4 25
1/8 50
1/16 75
1/32 100
release value 0
However, if you draw a controller curve for the Looper Touch Strip in your DAW, the KeyStep
Pro will respond to the values in the following way:
MIDI CC value received Looper Touch Strip region selected
1-25 1/4
26-50 1/8
51-75 1/16
76-100 1/32
136 Arturia - User Manual Keystep Pro - KeyStep Pro Configuration
To Next Page
Loading...
