Arturia KEYSTEP PRO - Front Panel Functions; The Tempo;Fine Encoder; Tap Tempo;Metronome Button; The Swing;Offset Encoder

8.3. Front Panel Functions
In Control mode, most of the performance controls in the left half of the KeyStep Pro's front
panel control the same functions as they do in normal mode, unless configured otherwise
using MIDI Control Center. There are some slight variations, though, which we'll point out as
we go through the performance controls:
8.3.1. The Tempo/Fine Encoder
The Tempo/Fine encoder works the same in all modes. Its functions are described in the
KeyStep Pro Overview Chapter. [p.14]
8.3.2. Tap Tempo/Metronome Button
The Tap Tempo/Metronome button works the same in all modes:
• Hold down SHIFT and press Tap Tempo/Metronome to toggle the Metronome ON/
OFF.
• Tap the Tap Tempo/Metronome button several times to set the tempo.
In MIDI Control Center [p.126] you can specify the number of taps it will take to set the
tempo.
8.3.3. The Swing/Offset Encoder
In Control mode, the Swing encoder controls the swing percentage of the entire Project. In
other words, the Swing percentage is applied to all tracks equally. For a description of the
Swing feature, see the Swing section of Chapter 6 [p.91].
8.3.4. Transport Section
The buttons of the Transport Section work the same way in Control mode as they do in the
other modes, unless set up otherwise using the MIDI Control Center.
Arturia - User Manual Keystep Pro - Control Mode 117