Page 2-3
Plug and Play Installation
Plug and Play Installation
The Asanté 10T Hubs are designed for plug and play installation. Before you
connect the hub to other devices, there are several things you should keep
in mind:
❏
When connecting two Ethernet devices (such as a hub,
Ethernet adapter, or 10BaseT MAU) together, you must
make sure that the total modular cable length is not
greater than 100 meters.
❏
When you connect two hubs together using the 10BaseT
ports, make sure the “OUT” port of one hub is con-
nected to the “IN” port of another hub.
❏
Network stations on the thin coaxial cable or thick cable
segment can also be connected to the hub.
❏
Network cable segments can be connected to or discon-
nected from the hub while the power is on. Plugging in
or removing network cable segments while the hub is
operating will not interrupt the operation of the hub.
❏
When you install the hub, you must avoid dusty loca-
tions, and avoid electromagnetically noisy areas.
10T Hub Ch 2 Page 3 Thursday, August 22, 1996 4:25 PM
To Next Page
Loading...
Need help?
General
