Asante MacCon Family Ethernet Network Cards for the Macintosh User Manual

i
Table of Contents
Asking for assistance i
Technical support hours i
Tell us what you think i
Introducing the
Asanté MacCon Cards 1-1
Summary of MacCon Card Features 1-2
The Math Co-processor Option 1-2
Asanté EtherTalk Installer Software 1-2
Installing Asanté MacCon Cards 2-1
Preparing for the Installation 2-1
Checking the Requirements 2-1
Observing the Safety Rules 2-2
The MacCon NuBus Card 2-3
Installing the MacCon NuBus Card 2-4
Installing the MacCon 610 Card 2-6
Installing a MacCon LC Card 2-9
Installing a MacCon LC Card in a Color Classic 2-10
Installing the MacCon3 IIsi and MacCon 30i Cards 2-13
Setting the Cable Type on the Daughter Card 2-13
Video Options 2-14
Setting the Slot Address for Two Cards 2-14
Installing the Math Co-processor 2-15
Installing in a Macintosh IIsi 2-16
Installing a MacCon3 IIsi and a Radius Pivot IIsi 2-18
Installing a MacCon Card in a Macintosh SE/30 2-19
Installing a MacCon+ SE Card in a Macintosh SE 2-21
Setting the Cable Type on the Daughter Card 2-21
Connecting the Macintosh to the Network 2-24
With 10BaseT cabling 2-24
Installing the EtherTalk Software 2-25
Two Types of Software Installations 2-25
About EtherTalk Phase 1 and Phase 2 2-26
Installation Procedures 2-26
Accessing Network Services 2-28
Asanté SNMP MacAgent 3-1
Introduction 3-1
TCP/IP Protocol Stack 3-1
IP Addressing 3-1
Requirements 3-2
AsantéView In-Band Network Management Software 3-2

Asante MacCon Family Ethernet Network Cards for the Macintosh Specifications

General

Brand	Asante
Model	MacCon Family Ethernet Network Cards for the Macintosh
Category	Network Card
Language	English