TD 92679EN
22 November 2013 / Ver. G
Installation Guide
Elise3
29
5. Working in Boot Mode
3 Click the “Browse...” and locate the software (.pkg) file to install.
4 Select where to save the software. If two versions of the software already have been
installed on the module choose which software to replace.
5 Select if the Elise3 shall be restarted after the installation or not.
6 If “Restart after installation” is selected, choose if the last used settings or the
factory default settings shall be applied on the new software.
If you choose “Do not restart”, you can later, when returning to normal operation,
choose and apply settings to software that is installed but not yet started.
NOTE: If current parameters cannot be used, i.e. if software of another type has been
installed, factory default parameters will always be used.
7 Click the “Install Software” button.
8 If “Do not restart” is selected a dialog window is shown. Click “OK”.
5.1.4 Return to Normal Operation
1 Click “Normal Operation”.
2 Select which software to start and click “OK”.
3 Select which settings to use for the software and click “OK”. The Elise3 will restart
and return to normal operation.
To Next Page
Loading...
