ASEM CPU 1021/A - Page 64

CPU 1021/A User’s Guide
56 Asem S.p.A.
PATA - Device 31, Function 1
Enables or disables the parallel ATA controller.
Default: Enabled
SATA - Device 31, Function 2
Controls mode of the SATA controller:
[Compatible (default]):SATA controller in legacy mode (activates the
primary channel of the PATA controller. The PATA devices are therefore
found on the secondary PATA channel). This allows easy installation of
the operating system without the need of the SATA drivers during
installation. [Enhanced]: SATA controller in native mode.
AHCI configuration: Disable / Enable.
Disable Vacant Ports
Automatically activates disabling of the non-connected SATA interfaces.
[Disabled (default]): The non-connected SATA ports are not
automatically disabled.
[Enabled]:The non-connected SATA ports are automatically disabled.
Azalia - Device 27
Azalia - Device 27, Function 0 [Default: Disabled]
Reserved
AC97A - Device 30, Function 2 [Default: Disabled]
Reserved
AC97M - Device 30, Function 3 [Default: Disabled]
Reserved