Asko WM70 - Page 33

Service manual WM70
33
Service menu WM70.3 cont.
Test motor, Testing Motor, Test motor,
Motortest, Tester motor, Test av
motor, Moottoritesti, Essai moteur,
Motor testen, Test motore, Test
motor, Teс т мoтoрa, Test motor
The motor is running at normal action (49 rpm)
Test drain, Testing Drain, Test
drain, Tömningstest, Tester
udpumpning, Test av tømming,
Tyhjennyspumpputesti, Essai
vidange, Abfluss testen, Test scarico,
Test drenaje, Teс т нaсoсa, Test
afvoerpomp
$RAIN PUMP IS ON 0RESSURE SENSOR VALUE IS SHOWN IN ,#$ 
Test spin, Testing Spin, Test
spin, Centifugeringstest, Tester
centrifugering, Test av sentrifugering,
,INKOUSTESTI %SSAI ESSORAGE
Schleudern testen, Test centrifuga,
Test centrifugado, Teс т oтжим a, Test
centrifugeren
A Spin sequence is performed, the drain pump is running. Unbalance value is shown in
,#$ 
Test door, Testing Door, Test door,
Dörrtest, Tester luge, Test av dørlås,
,UUKUN LUKON TESTI %SSAI PORTE ,UKE
testen, Test sportello, Test puerta,
Teс т зaмкa двeрцы, Test deurslot
Door lock is activated, the door is then opened.
Press to exit the service menu
0
3ETTING AMOUNT OF WATER TAKEN INTO THE MACHINE $EFAULT VALUE IS vv
-15%
-10%
-5%
+5%
+10%
+15%
Press to exit the service menu
0
!DJUST WATER INLET VOLUME $EFAULT VALUE IS v
+3
+2
+1
-1
-2
-3
Press to exit the service menu
Rinses3, Rinses3, Rinses3, Sköljning3,
Skylninger3, Skylling3, Huuhtelut3,
Rinçage3, Spült3, Risciacqui3,
Enjuagues3, o o a e3, Spoelen3
Adjusting the default setting for rinsing (default = 5 rinses). Setting can be made in
heavy (Program 2), White (3) colour (Program 4)
Rinses5, Rinses5, Rinses5, Sköljning5,
Skylninger5, Skylling5, Huuhtelut5,
Rinçage5, Spült5, Risciacqui5,
Enjuagues5, o o a e5, Spoelen5
Press to exit the service menu