Aspion G-Log 2 - Page 10

To Next Page

To Previous Page

ASPION G-Log shock sensors / Conformity declarations

FCC / ISED compliance statement

This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference, including interference that may cause undesired operation of the

device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de

brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

FCC / ISED Caution Statement for Modifications:

Aspion has not approved any changes or modifications to this device by the user. Any changes or

modifications could void the user’s authority to operate the equipment.

Aspion n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit la

nature.Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par

l’utilisateur.

FCC / ISED Wireless notice

This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment and

meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency (RF)

Exposure rules. This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour un environnement

non contrôlé et répond aux directives d'exposition de la fréquence de la FCC radiofréquence (RF) et RSS-

102 de la fréquence radio (RF) ISED règles d'exposition. L'émetteur ne doit pas être colocalisé ni

fonctionner conjointement avec à autre antenne ou autre émetteur.

FCC Information for a Class A (industrial use) digital device

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which case the

user will be required to correct the interference at his own expense.

FCC Mobile Device RF Exposure Statement

This device is only authorized for use in a mobile application. At least 20 cm of separation distance between

the (Product Name) device and the user's body must be maintained at all times.

Other manuals for Aspion G-Log 2