ASPION G-Log shock sensors / Mounting
User manual – Version 3.2/11-19 Copyright © ASPION GmbH Page 11
5. Mounting
5.1 Mounting orientation
To correctly assign the axes in case of shock
events, the mounting orientation is critical.
Recommended mounting
On steel: M3 ISO 7380 FL
On wood/sheet metal: flathead screws with
a maximum thread diameter of 3.5 mm
(e.g. DIN 7981)
Maximum tightening torque: 0.4 - 0.5 Nm
Alternatively, you can use industrial adhesive tape
(e.g. 3M) for fixing.
When mounting the ASPION G-Log 2, make sure that you do not damage the lateral membrane used to
protect the humidity sensor from splashing water.
5.2 Housing dimensions and mounting template
Housing cross section
Housing dimensions
To easily mount the sensor, copy this mounting template (scale: 1:1).
Dimensions in millimeters
Dimensions in millimeters
To Next Page
Loading...
