ASROCK GENOAD12M3-2Q - Jumper Setup

GENOAD12M3-2Q
GENOAD12M3-2Q/H
GENOAD12M3/T
22 23
English
2.6 Jumper Setup
e illustration shows how jumpers are setup. When the jumper cap is placed on the pins,
the jumper is “Short”. If no jumper cap is placed on the pins, the jumper is “Open”. e
illustration shows a 3-pin jumper whose pin1 and pin2 are “Short” when a jumper cap is
placed on these 2 pins.
NCSI Mode Jumper
(3-pin NCSI_SEL1)
(see p.6, No. 41)
NCSI for BCM7414
(Default)
NCSI for OCP NIC
Chassis ID Jumper
(3-pin CHASSIS_ID0)
(see p.6, No. 42)
Pull-up, for BMC further
use (Default)
Pull-down, for BMC further
use
OCP3 +12VSB Power Jumper
(3-pin +12VSB_SEL1)
(see p.6, No. 50)
Enable +12VSB for OCP3
PWR (Default)
Disable +12VSB for OCP3
PWR